Detaylı Arama

İptal

Bulunan: 281 Adet 0.002 sn

- Eklemek veya çıkarmak istediğiniz kriterleriniz için 'Dahil' / 'Hariç' seçeneğini kullanabilirsiniz. Sorgu satırları birbirine 'VE' bağlacı ile bağlıdır.
- İptal tuşuna basarak normal aramaya dönebilirsiniz.

Filtreler

Bulunan: 281 Adet 0.002 sn

Yayın Tarihi : 2017 ✕

Koleksiyon [19]

İlgili Araştırmacılar [20]

Ambargo Durumu [1]

Tam Metin [2]

Yayın Türü [9]

Yazar/lar [20]

Atıf Dizini [5]

Yayıncı [20]

Tez Danışmanı [4]

Dergi Adı [1]

Yayın Tarihi [1]

Tez Türü [2]

Yayın Dili [4]

A Realistic View on

BAHADORI, Fatemeh | DEMİRAY, Mutlu

The review paper entitled “The Essential Medicinal Chemistry of Curcumin”, published in the Journal of Medicinal Chemistry, by Nelson et al. (1) is a well-designed paper, presenting a new (and negative) approach to the well-known biologically active compound; curcumin. Although some arguments throughout this paper are completely true, the approach of the authors is unfortunately far from impartial, and many of the conclusions the authors draw from some of their referred papers are especially hard to accept.

Makale 2017 5 Görüntülenme

Erişime Açık

Validity and Reliability Study of Environmental Awareness and Attitude Scale for Preschool Children

BÜYÜKTAŞKAPU SOYDAN, Sema

The aim of this study is to conduct validity and reliability study of the Environmental Awareness and Attitude Scale for Preschool Children .This study is conducted with 310 children who are having preschool education. At the end of the factor analysis results, there are three factors that explain 44.02% of the total variance in Environmental Attitude subscale. In the Environmental Awareness subscale, 3 factors that explain 40.94% of total variance were found. The correlation coefficients between the factors of the Environmental Awareness subscale were r =.80, .78 and .83 and for the Environme ...Daha fazlası

Makale 2017 International Electronic Journal of Environmental Education 6 Görüntülenme

The Effects of Training on Knowledge and Beliefs About Breast Cancer and Early Diagnosis Methods in A Group of Women

YILMAZ, Meryem | SAYIN, Yazile | ÖNER CENGİZ, Hatice

Objective: Breast cancer (BC) is the most common female malignancy in the world and Turkey. Its prevalence and mortality are surprisingly increasing at a rapid rate. The objective of this study was to determine the effectiveness of training sessions on women’s knowledge of relevant risk factors of BC and screening methods, screening behaviors and health beliefs among of healthy women in Turkey. Materials and Methods: In this study, in order to establish the efficiency of BC training, a semi-empirical single group pre-test & post-test research model was used. The data were collected by using a ...Daha fazlası

Makale 2017 2 Görüntülenme

Effect of Sr and Ti Addition on the Corrosion Behavior of Al-7Si-0.3Mg Alloy

ÇETİN, Remzi | ULUDAĞ, Muhammet | KOÇABAŞ, Mustafa | DIŞPINAR, Derya | CANSEVER, Nurhan

In the present study, the corrosion behaviour of A356 (Al-7Si-0.3Mg) alloy in 3.5% NaCl solution has been evaluated using cyclic/potentiodynamic polarization tests. The alloy was provided in the unmodified form and it was then modified with AlTi5B1 for grain refinement and with AlSr15 for Si modifications. These modifications yield to better mechanical properties. Tensile tests were performed. In addition, bifilm index and SDAS values were calculated and microstructure of the samples was investigated. As a result of the corrosion test, the Ecorr values for all conditions were determined approx ...Daha fazlası

Makale 2017 Archives of Foundry Engineering 3 Görüntülenme

Characterization of the Effect of Melt Treatments on Melt Quality in Al-7wt %Si-Mg Alloys

ÇETİN, Remzi | ULUDAĞ, Muhammet | DIŞPINAR, Derya | TİRYAKİOĞLU, Murat

The effects of degassing, holding time and melt additions (Sr, Sr + Ti, Ti, B and B + Sr) on the quality of A356 melts were examined. A total of 120 reduced pressure test samples were collected. Pores in these samples were analyzed via digital image processing to determine the number density of pores as well as the statistical distribution of their sizes. Results showed that in all cases, degassing with argon reduced the number of defects regardless of the additions made to the melts. Moreover, all additions were found to degrade melt quality. The lowest number density of pores in all melts wa ...Daha fazlası

Makale 2017 METALS 6 Görüntülenme